CH C C20 C C CH CH CHA ALPHA CHE .. General Plant/Equipment Reactors – Alloy Atmos Press Bottlers Generator Skôr ako uvediete spotrebi do prevádzky Preítajte si, prosím, pozorne návod na.
|Published (Last):||9 May 2014|
|PDF File Size:||13.62 Mb|
|ePub File Size:||2.39 Mb|
|Price:||Free* [*Free Regsitration Required]|
In cases of personal wells, the boiler can be additionally protected by using a back-up power supply battery with an exchanger for operation back up of at least one pump. They should only be operated by adults. The atmox is obliged to adhere to instructions from the operation and maintenance manual. Boiler bases We recommend providing a concrete metal base under the boiler.
GB Setting Heat the boiler to approx. Instruction manual – GB All boilers are equipped with a cooling loop protecting them against overheating. Date of last inspection: We recommend the latter. Opravu provedl, datum Oprava: Otherwise, the boiler and ventilator may get covered in tar and their service life would be reduced. The boiler is set to optimal operating parameters by the manufacturer.
The purchaser was familiarised with the use and operation of the product — in a provable way. If the installation was not carried out in a professional manner, the subsequent costs are borne by the company that carried out the installation. This thermostat must be pressed down in case that boiler overheating occurred. The network connection is of the M type and when replacement is needed the service company must use the same type connection to replace it.
If the accumulation method cannot be used, then we recommend using at least one tank of – 1, litre volume for equalising the boiler start-ups and run-outs. Place paper or wood wool on top of the kindling, then another layer of kindling and larger amount of dry wood. The actual slow-burn combustion time depends on the amount of fuel placed in the boiler and on the actual quantity of consumed heat. We recommend cleaning the boilers once a week if burn- GB www.
Návod k obsluze
Prepare the boiler for slow-burning operation in the following way: For the heating system regulation we recommend regulation elements provided by the following companies: Use also a poker or a brush to remove dust sediments from the lower combustion chamber walls.
The boiler operates environmentally friendly if working at the nominal output level. If the side play is lower than that, reduce one ore more segments by the necessary thickness. Use a screwdriver atkos remove the old sealing cord and to clean the groove in which it was seated.
CAUTION — when operating the boiler, all doors must be fully closed and the ignition valve pulling rod must be pushed in – otherwise the atmow S may sustain damage. Shift the control panel forward and tilt it to a side. If need be, a thermoregulatory valve set to a higher temperature E.
Otherwise, the ventilator S may sustain damage. GB Hot-water boiler 2.
It is necessary to seek and discover an optimal position of the thermostat; which depends on type of fuel, chimney draught and other conditions. Take the boiler drum and hood to a scrap-metal collection site.
By following these steps in reverse order, you can replace the door. A control panel for electromechanical regulation is situated in the upper part of the boiler. Area for electronic regulation of the heating system 92x mm Description: The regulation is based on the pre-set outgoing temperature value.
This feature means fuel savings and environmentally friendly operation. The boiler is not intended for burning saw dust or small-particle wood waste. If you want the ventilator to start operating again, set a lower temperature on the waste gas thermostat e. The boilers have the primary and secondary air pre-heated to a high temperature.
Connection of these elements is illustrated in the wiring diagram.
Návod k obsluze – Spotřebiče
These are appropriate for mobile installations, wooden cottages etc. Slide the grating tube back in position and place the individual segments back on it, one by one. Both the pumps may however be switched by just one thermostat.
The user must not tamper with the boiler construction or its electrical installation.