View and Download Akai S service manual online. Midi stereo digital sampler. S Music Equipment pdf manual download. Akai S Pdf User Manuals. View online or download Akai S Service Manual. Full text of “Akai: S SERVICE MANUAL”. See other formats. OOL US MIDI STEREO DIGITAL SAMPLER SPECIFICATIONS MODEL Display Backlit

Author: Gasida Kigalabar
Country: Niger
Language: English (Spanish)
Genre: Travel
Published (Last): 3 August 2011
Pages: 248
PDF File Size: 5.53 Mb
ePub File Size: 12.32 Mb
ISBN: 827-3-50977-405-8
Downloads: 46413
Price: Free* [*Free Regsitration Required]
Uploader: Dok

I think they may contain the OS which, when loaded into the s, is causing the problem. Additionally S is faster and it has louder outputs due to 20bit converters while samples are still 16bit some infos: January 21, Reply. When it comes to vocals, a decent microphone will make more of a difference to the recorded sound than any amount of later editing or tweaking.

How i noticed this? Best, Nikolas November 10, Reply.

Akai S1100 Service Manual

In this situation samples need manjal headroom. The leakage-current should be less than 0. Unfortunately midi implementation is very limited, there is no resonance and it has only 16 voices of polyphony.

Eingestellt von akai-sampler um RF converters, tuner units, antenna s110 switches, RF cables, noise blocking capacitors, noise blocking filters, etc.

This is independent of gain, volume settings.

Twenty seconds later you’ll have a fully formatted disk, ready to roll. This is not audible on audio channels, its just from inside of sampler.

As addition two OS diskettes included and one diskette with couple of samples to check the machine after purchase. I have sxl with fx board, but i never loaded samples from s to my s unit. But i have few instruction how to save it on floppy. I just found similar tutorial how to put cf inside akai s at Mike Bass Page: A good microphone technique is also encouraged — try to get as high a level as you can sung into the mic, and if your vocalist has a soft or quiet voice try to use an active or phantom-powered microphone, as these usually produce a higher output level.


Here’s a never-before-revealed, exclusive Chris Carter tip for users of Ss with the IB interface fitted. These must also be replaced only with specified re- placements. The units have 2Mb memory boards as standard but this deal also includes 2 8Mb boards. For some reason Akai have a formatting limit of Mb, no matter what size the hard disk, so Jaz drives are out!

You will need a scsi cable to link these 2 up, this will cost a couple of pounds only. FX unit on the s is completely different and this is impossible to translate effect data from s to s Even so, there are hidden depths to the S and a lot of parameters to wade through, and many people just use the basic sampling, editing and playback functions — so if you’re considering HD recording, and have access to an S, the following tips could help you achieve some rewarding results, though they should also be applicable to users of later Akai samplers with HD recording facilities.

Akai S / S – Martincom

The S was launched in as a replacement for the highly respected but ageing bit, voice S As most hard-up musicians know, the running costs on a track tape machine can be a real burden and you’re tempted to start ‘economising’ by re-using tape and skimping on servicing — both big mistakes.


But in my opinion this is rather bug than adefect. The note should be placed a couple of seconds in front of where the S will drop into record or playback.

Observe that wires do not contact heat producing parts heatsinks, oxide metal film resistors, fusible re- sistors, etc.


Next Akai units, like s use simple linear interpolation and samples, especially with lower frequency than manuxl 44,1khz sounds dull, and you get stronger antialiasing. Akai’s S hard-disk recording option caused quite a buzz on its release, and even now makes this well-specified sampler even more versatile. You have to edit or disable fx on s Connect a DAT machine to the IB interface, using the co-ax or optical connectors, and begin the backup see the ‘Stick to I know that s reverb is much better: Mine s starts buzzing after few minutes, but this sound comes from inverter.

Save it to blank floppy by executing downloaded file.

Akai S1000 / S1100

In this case check the memory circuit and LSI. The re- sistance should be more than 2. I have an internal jaz drive installed in my s1010 Make your adjustments and return to the TAKE page. I thought my FX card was broken, as whenever I engaged any reverb it would give weird digital noise and distortion. I have two leads for use with the RSDO: